Why does my CPC hand control say Transmit Data?

It appears that your hand control is stuck in programming mode. 

Fortunately, it can be solved easily:

1. Cycle the power of your scope. This will often clear the condition.

If you have an RS-232 cable (the cable that attaches between your computer's serial port and the port on the bottom of the hand control) you will be able to download the HCupdate program that will allow you to reprogram the hand control.  This is available for free download off of our web site,
celestron.com/downloads

Complete instructions on how to do the reflashing are elsewhere in the Knowledgebase, “How to Flash Update your Hand Control and Motor Control Firmware“.

If you are unable to program the hand control, or if this problem continues after attempting to program it, your hand control needs to be replaced. Please contact Celestron Technical Support.


Updated 12/24/13